Base TS base/plinth Base mounting plate Packs of Part No. for 10 2817.000 – TS base/plinth – base/plinth, complete For fastening the base/plinth to the floor without moving the enclosure or the bayed enclosure suite. For assembly screws up to 12 mm Ø. Material: Carbon steel Surface finish: Zinc-plated Fastening bolt Base/plinth trim panel Packs of Part No. for inches (mm) high – TS base/plinth 4” (100) 10 2819.000 – Base/plinth, complete – Base/plinth, stationary 8” (200) 10 2819.200 For mounting on base/plinth trim panels, side. The lockable assembly bolt allows the installation of cable clamp rails. Tighten with hex spanner, width across flats 19 mm Material: Hexagon steel Surface finish: Zinc-plated 1) 1671) 117 67 Accessories: Cable clamp rail, see page 723 Levelling component For for TS base/plinth base/plinth height Packs of Part No. For retrospective levelling of floor unevenness at inches (mm) the installation site up to a maximum of 15 mm. 4” (100) 4 2891.000 Installed through the corner piece of the base/ 8” (200) 4 2892.000 plinth component. Adjusted using a SW 19 hex spanner. Benefits: – A door offset caused by uneven flooring can be corrected – Installed on the assembled enclosure i.e. no need to plan levelling in advance Max. admissible static load: 562 lb (2500 N) per levelling component (check the load capacity of the floor) Configuration: Assembly parts 536 Metric measurements for are exact, imperial measurements are rounded Rittal Catalog 33/System accessories
rittal
To see the actual publication please follow the link above