Base TS base/plinth Base/plinth component For enclosure width Height Part No. front and rear inches (mm) inches (mm) Stainless steel for TS, CM 24 (600) 4 (100) 8701.600 32 (800) 4 (100) 8701.800 Material: Stainless steel Type 304 47 (1200) 4 (100) 8701.200 Surface finish: Brushed, grain 400 24 (600) 8 (200) 8702.600 32 (800) 8 (200) 8702.800 Configuration: Mounting accessories for mounting on the enclosure 47 (1200) 8 (200) 8702.200 4" (100 mm high): 2 trim panels front/rear Accessories: Base/plinth trim, modular (perforated plate), see below 8" (200 mm high): − 2 corner pieces with removable trim panel − 1 trim panel front/rear Base/plinth trim panel, side For enclosure depth Height Part No. Stainless steel for TS, CM inches (mm) inches (mm) For mounting between the base/plinth 16 (400) 4 (100) 8701.040 components. At 8” (200 mm) height, two 4” (100 mm) base/plinth trims may be used. Base/plinth 20 (500) 4 (100) 8701.050 trim (4” (100 mm high)) may be installed 24 (600) 4 (100) 8701.060 rotated through 90° in order to stabilize bayed 32 (800) 4 (100) 8701.080 base/plinth components. 16 (400) 8 (200) 8702.040 Material: 20 (500) 8 (200) 8702.050 Stainless steel Type 304 24 (600) 8 (200) 8702.060 Surface finish: Accessories: Brushed, grain 400 − Assembly bolts for base/plinth, see page 536 − Levelling feet 4612.000, see page 547 Configuration: 2 base/plinth trim panels, including parts for Detailed drawings: attaching to the base/plinth components Available at www.rittal-corp.com Also required: Base/plinth baying brackets 8601.100, see page 534, when mounting base/plinth trim panels rotated through 90° Base/plinth trim, modular For enclosure depth Packs of Part No. for inches (mm) – TS base/plinth 16 (400) 4 2907.000 – base/plinth, complete, stainless steel For cable routing in the stainless steel base/plinth, 20 (500) 4 2908.000 e.g. if levelling feet 2890.000 or 2890.000, 24 (600) 4 2913.000 see page 545, are used. Width: 7” (175 mm). Accessories: Material: Cable tie 2597.000, see page 726 Stainless steel Type 304 Configuration: 4 base/plinth trim panels. Note: One base/plinth trim panel is needed per 8” (200 mm) base/plinth width. Rittal Catalog 33/System accessories Metric measurements for are exact, imperial measurements are rounded 539
rittal
To see the actual publication please follow the link above