Walls Divider panels/partitions Module plate Design Cut-outs Packs of Part No. Solid – 1 8609.160 Material: Carbon steel, 14 ga (2.0 mm) For 16-pole 4 1 8609.150 connectors Surface finish: For 24-pole 4 1 8609.140 Zinc-plated connectors For cable Configuration: entry 1 1 8609.170 Seal For cable entry 4 1 8609.190 grommets With cable 1 1 8609.390 sleeve Solid Accessories: For sealing unused cut-outs. Easily machined − Adaptor, cover plate, see page 570 for individual cut-outs. − Connector gland for connector cut-outs, see page 718 − Connector gland sealing frame and sealing module, see page 720 for 16/24-pole connectors Accessories: With cut-outs to accommodate connectors. In Cable tie for fast assembly 2597.000, addition to mounting on divider panels, module see page 726 plates may also be attached to the 25 mm pitch pattern of the enclosure and to the rails of the TS/PS system. For cable entry Also required: For the entry of pre-assembled cables. Sealed, − Cable entry grommets, see page 708 secure routing is achieved via adjustable angle or brackets with inserted foam cable clamp strip. − Connector grommets, see page 708 Attachment bracket, punched, for cable clamping. For cable entry grommets For mounting on the divider panel for module plates TS. Slide the grommets into the cut-outs, slide the clamp plate with seal down over them, and screw-fasten. With cable sleeve For 0.4" – 2.6" (10 – 65 mm) cable diameters. The flexible grommet adapts to the cable’s bending radius. Rittal Catalog 33/System accessories Metric measurements for are exact, imperial measurements are rounded 569
rittal
To see the actual publication please follow the link above