Baying system Enclosure suites Baying attachment, vertical Packs of Part No. for TS/TS 4 8800.670 For baying two populated enclosures on the vertical enclosure section. Simply locate into Material: the vertical TS punchings, secure and connect Carbon steel, 11 ga (3.0 mm) both brackets by using the hex screws (supplied loose). Using the fastening bolts, the enclosure is Surface finish: pulled into a defined end position, with a height or Zinc-plated side offset of up to ± 0.08” (2 mm). Configuration: Assembly parts Baying clamp, horizontal Packs of Part No. for back-to-back mounting 4 8800.170 Two-piece, for assembly of enclosures with mounting panel in the rearmost installation position. Material: Carbon steel Surface finish: Zinc-plated Configuration: Assembly parts Baying cover, top For Stainless A cover with two end caps may additionally be enclosure Packs RAL steel Part No. clipped over the seal between the two enclosures. depth of 7035 Type 304 This prevents dirt and liquid from collecting inches (mm) on the baying seal. 16 (400) 1 – 8800.840 20 (500) 1 – 8800.850 Material: − Cover section: Carbon steel or stainless steel 24 (600) 1 – 8800.860 − End caps: Plastic 32 (800) 1 – 8800.880 39 (1000) 1 – 8800.892 Surface finish: Spray-finished 16 (400) 1 – 8700.140 20 (500) 1 – 8700.150 Configuration: 24 (600) 1 – 8700.160 − Cover section − 2 end caps Note: May be fitted in the width with enclosure suites bayed back-to-back. Can be used in conjunction with dust guard trim, see page 620. Cannot be used in conjunction with Type 4/4X baying kits. 578 Metric measurements for are exact, imperial measurements are rounded Rittal Catalog 33/System accessories
rittal
To see the actual publication please follow the link above