Doors/locks Door, internal Support strip Material: For attachment of Carbon steel – Cable ducts – Cable conduit holders Surface finish: – Contact hazard protection covers Zinc-plated – Equipment installed on the door – Cable clamping and attachment Configuration: – 4.5 mm diameter hole on a 25 mm DIN Packs of 20 (screws included) pitch pattern Accessories: Screws and self-tapping screws M5, see page 674 For TS, CM, ES, TP For door width Length Part No. inches (mm) inches (mm) 16 (400) 12 (290) 4594.000 20 (500) 15 (390) 4309.000 24 (600) 19 (490) 4596.000 32 (800) 27 (690) 4598.000 35 (900) 31 (790) 4579.000 39 (1000) 35 (890) 4599.000 For AE For AE Enclosure Part No. 1018.6002), 1019.5002), 1050.5001), 1057.500, 1100.500, 1110.500, 2325.000 1114.5001), 1130.500, 1213.5001), 1350.5001) 1009.6002), 1012.5002), 1039.500, 1054.500, 1058.500, 1060.500, 2326.000 1076.500, 1090.500, 1260.50011), 1339.500, 1360.500, 1376.500 1014.5002), 1073.500, 1077.500 2327.000 1016.5002), 1017.5002), 1055.500, 2328.000 1180.500, 1280.5001) 1) For these AE models, the support strips should be cut to length at the knockout. 2) Only in conjunction with perforated mounting strips (see page 615). Spacers Length Packs of Part No. The universal assembly component for all cases inches (mm) where a distance from the mounting level is 1 (25) 12 2311.225 required. With self-tapping thread for diameter 4.5 mm. The following components may be 2 (50) 12 2311.250 attached to the rear using 5.5 x 13 mm screws: – Top-hat/cross rails – Contact hazard protection covers – Master switch trim panels – Cable clamp rails, etc. 25 Material: Hexagonal steel (SW8) Surface finish: Zinc-plated 50 Accessories: Screws 5.5 x 13 mm, see page 674 614 Metric measurements for are exact, imperial measurements are rounded Rittal Catalog 33/System accessories
rittal
To see the actual publication please follow the link above