Interior installation Mounting panel Partial mounting panel Material: for TS, CS Toptec Carbon steel, 10 ga (2.5 mm) For – Universal interior installation, also in conjunction Surface finish: with punched sections with mounting flanges Zinc-plated and support strips. Defective assemblies are quickly and easily replaced Configuration: – Additional mounting levels Assembly parts Partial mounting panels are fastened directly onto Accessories: the vertical enclosure sections via the inner − TS punched section with mounting flange mounting level using the assembly parts supplied 17 x 73 mm for the outer mounting level, loose. In this mounting position (in both the see page 652 width and the depth) they form one level with TS − TS support strip, see page 656 punched sections with mounting flanges 17 x 73 − Hinge attachment, see page 641 mm and TS support strips for the inner mounting − Self-tapping screws, 2487.000, see page 674 level. Enclosure width inches (mm) Enclosure depth (side) inches (mm) Size Packs 16 24 32 39 47 16 20 24 32 inches (mm) of Part No. (400) (600) (800) (1000) (1200) (400) (500) (600) (800) 20 x 12 (500 x 300) 1 8614.640 20 x 16 (500 x 400) 1 8614.650 20 x 20 (500 x 500) 1 8614.660 20 x 28 (500 x 700) 1 8614.680 20 x 31 (500 x 775) 1 8614.6751) 28 x 12 (700 x 300) 1 8614.840 28 x 16 (700 x 400) 1 8614.850 28 x 28 (700 x 700) 1 8614.880 35 x 12 (900 x 300) 1 8614.040 35 x 16 (900 x 400) 1 8614.050 35 x 20 (900 x 500) 1 8614.060 43 x 12 (1100 x 300) 1 8614.240 43 x 16 (1100 x 400) 1 8614.250 43 x 20 (1100 x 500) 1 8614.260 1) Also suitable for installing in – PC enclosures based on TS behind the lower front door – IW enclosures, height 35” and 39” (900 and 1000 mm) 1 2 When installing around corners due to collision Set forward installation position between the assembly components Quickly and easily achieved wtih four TS punched 1 At least 75 mm, adjustable on a 25 mm pitch pattern. sections with mounting flanges 17 x 73 mm for the Maximum space utilization outer mounting level, see page 652. 2 1 mm (adjustable on a 25 mm pitch pattern). Partial installation Continuously flush Partial utilization of the enclosure depth or width is also In bayed enclosures, the partial mounting panel is possible. In this example, using a PS punched section in the rear most position flush with the standard without mounting flange 23 x 73 mm, see page 658. mounting panel. This facilitates continuous component mounting. 640 Metric measurements for are exact, imperial measurements are rounded Rittal Catalog 33/System accessories
rittal
To see the actual publication please follow the link above