Cable management Cable entry Section for cable entry, rear For enc. width Packs of Part No. for TS, CM, TP inches (mm) Unlike the section for cable entry, center, the rear 24 (600) 1 set 8802.065 section is mounted directly onto the base opening. In this way, when installing the mounting 32 (800) 1 set 8802.085 panel in the rearmost position (TS) or with CM, the 39 (1000) 2 sets 8802.105 cables may be routed directly on a cable 47 (1200) 2 sets 8802.125 clamping rail with no large radii. In conjunction with the cable clamp rail, optimum adjustment 63 (1600) 2 sets 8802.165 between the cable entry and mounting panel can be achieved. Material: − Extruded aluminum section − Seal: PU foam − Cross-section: 1.2” x 1.0” (30 x 25 mm) Protection rating: IP 55 subject to correct mounting Note: 1 set is sufficient for one base opening up to an enclosure width of 32” (800 mm). From an enclosure width of 39” (1000 mm), two base openings are provided. 2 sets per enclosure may be fitted. Accessories: Cable clamp rail, see page 723 Foam rubber cable clamp strip Length Part No. For sealing the cable entry between the gland 118” (3000 mm) 2573.000 plates. Particularly suitable for identical cable cross-sections. Material: − PU foam − Cross-section: 1.2” x 1.2” (30 x 30 mm) Protection rating: IP 55 subject to correct mounting EMC gland plate see page 697. Rittal Catalog 33/System accessories Metric measurements for are exact, imperial measurements are rounded 709
rittal
To see the actual publication please follow the link above