Page 755

rittal

19” (482.6 mm) installation system Mounting angles Adaptor section, Accessories: − Infill panels, see page 754 19” (482.6 mm) − Captive nuts, see page 673 for TS − Assembly screws, see page 674 For the installation of subracks and other − Slide rails with one-sided mounting, equipment. Mounting angles are easily shortened see page 765 for partial assemblies. − Slide rails with two-sided mounting, see page 765 Configuration: − Drawer installation kit, see page 767 Assembly parts − Component shelf installation kit, see page 676 Note: The 19” (482.6 mm) measurement is obtained when mounting on the TS frame for enclosures with width 24” (600 mm). For enclosure system TS1) For enclosure height Material U Packs of Part No. inches (mm) 63 (1600) 32 4 8613.060 71 (1800) 38 4 8613.080 79 (2000) Extruded aluminum section 42 4 8613.000 87 (2200) 47 4 8613.020 For PC enclosure2) 17 4 8613.070 1) For the rear of electronic enclosures, see page 754. 2) Behind lower door. Assembly examples of TS: Drawing 1 Drawing 2 Drawing 1 and 2: Mounting angle or adaptor piece fitted in the foremost installation position, directly on the vertical section. When installing slide rails with two-sided mounting (see 1 1 page 765), the same mounting angles or adaptor pieces must also be mounted on the vertical section at the rear. 43 63 63 5 75. 3 4 Drawing 3 Drawing 5 Drawing 3: Mounting on two vertically 5 installed PS punched sections permits fully flexible use of the enclosure depths. Drawing 4 1 Greater distance from the doorDrawing 4 and 5: 1 is achieved by mounting on 2 adaptor rails for PS compatibility. 2 86 5 In this position, the slide rails6698.86 can be fitted with one-sided mounting. 3 4 1 Adaptor section/piece 4 TS glazed door 2 Adaptor rail 5 Punched sections without mounting flanges 3 TS carbon steel door Rittal Catalog 33/System accessories Metric measurements for are exact, imperial measurements are rounded 753


rittal
To see the actual publication please follow the link above