Interior installation Mounting panel Mounting panel attachment Material: Carbon steel For additional clamping and to reduce potential vibration of the mounting panel. Select according Surface finish: Zinc-plated to mounting position, installation type and enclosure. Configuration: Assembly parts For TS Packs of Part No. Installation options: – Side, at half height in conjunction with 10 8800.630 mounting panel infill – In the penultimate position Accessories: – Set forward (supplied state) Mounting panel infill, see page 635 Benefit: No impairment to the mounting surface, but mounting is only possible from the enclosure rear. For TS Packs of Part No. Installation options: – Side 10 8800.610 – Rear, flush with enclosure frame Benefit: No impairment to the mounting surface, but mounting is only possible from the enclosure rear. For TS Packs of Part No. Installation options: – Side 10 8800.090 – Rear, flush with enclosure frame – Set forward on a 25 mm pitch pattern Also required: Punched section with mounting flange 17 x 73 Benefit: No impairment to the mounting surface. mm for the inner mounting level, see page 652 May optionally used for attachment or screw (with Fig. 3) fastening. 1 Mounting panel screw-fastened in the rearmost installation position. 2 Mounting panel screw-fastened from the rear in the rearmost installation position. 3 Mounting panel in a set forward position, either attached (shown) or screw-fastened (not shown). 1 2 3 For TS Packs of Part No. Installation options: 10 8800.050 – Side – Rear, flush with enclosure frame Slide over the plate at the side and secure with screws. Additionally, the mounting panel may be drilled and screw-fastened at the rear C-edge. 636 Metric measurements for are exact, imperial measurements are rounded Rittal Catalog 33/System accessories
rittal
To see the actual publication please follow the link above