Interior installation Mounting panel Mounting panel attachment Material: Carbon steel For additional clamping and to reduce potential vibration of the mounting panel. Select according Surface finish: Zinc-plated to mounting position, installation type and enclosure. Configuration: Assembly parts For TS, ES Packs of Part No. Installation options: 10 4593.000 – All-round – Set forward on a 25 mm pitch pattern Also required: − Support strip (with TS for inner level), Slide in between the bar and plate from see page 656 or below or above or from the side, and secure with − Punched section with mounting flange screws. (with TS for inner level), see page 652 or − Punched rails and punched sections without mounting flange, see page 658 For TS, ES Packs of Part No. Installation options: – On the top and bottom of the mounting 10 4576.000 panel (TS) or all-round (ES) – Rear, flush with enclosure frame Screw in the clip behind the plate and secure with screws. Installation kit Packs of Part No. for mounting panels TS, back-to-back 1 set 8800.280 The minimal distance between the two mounting plates ensures a maximum installation depth for installed equipment on both sides. Material: Carbon steel Surface finish: Zinc-plated Note: Build height front and rear, with central installation = (enclosure depth – 1.9" (48 mm)) Example: 8806.521 = Depth 24" (600 mm) Build depth = 2 x 10.9" (276 mm) Rittal Catalog 33/System accessories Metric measurements for are exact, imperial measurements are rounded 637
rittal
To see the actual publication please follow the link above