19” (482.6 mm) installation system 19” (482.6 mm) installation Air baffle plate For enclosures for TS Packs Targeted air routing to the components. To prevent inches (mm) inches (mm) ofDepth Part No.Width bridges between hot and cold air. Energy efficiency is boosted while retaining cooling 24 (600) 79 (2000) 2 7151.206 output. Mounted all-round on the 19” (482.6 mm) 32 (800) 79 (2000) 2 7151.208 installation between the 19” (482.6 mm) mounting frame and modular LCP, LCP Plus, side panel or Material: partition. The width-variable air baffle plates may − Air baffle plates: Carbon steel, spray-finished be individually adapted to suit the requirements. − Stepped collar: Plastic, to UL 94-V0 In the variant for 32” (800 mm) wide enclosures, − Blanking panel: Plastic, to UL 94-V0 vertical 19” (482.6 mm) mounting holes of 3 x 1 U are additionally integrated, which may be used for Color: configuration with additional components. Cable RAL 7035 glands with stepped collars distributed across the height facilitate shielded cable routing between Configuration: the front and rear chamber. In the delivered state, − 2 air baffle plates, side, width-variable these openings are each covered with a 1 U − 1 air baffle plate, top, horizontal blanking panel with snap-in fastening. − With 32" (800 mm) width including blanking panel and stepped collar Note: Mounting on the inner and outer mounting level in the enclosure depth is not possible. Infill panel, hinged Trim panel curved for 32” (800 mm) wide TS network enclosures For installation To cover the side cable chamber. The infill panel height U Packs of Part No. is attached to the vertical enclosure frame at the front. The generous curved design will conceal 38 2 7827.5321) even large quantities of cables, and facilitates 42 2 7827.534 combined use with large-scale shunting rings 47 2 7827.536 7220.600, see page 733. The infill panel has a hinged design and allows easy access to the 1) Extended delivery times. cabling level by simply swinging it upwards. Locating points keep the panel in its open and Trim panel straight closed state. With an offset 19” (482.6 mm) mounting level, the panel may likewise be For installation Packs of Part No. offset in the enclosure depth and secured to TS height U punched sections with mounting flange on the 42 2 7827.5201) inner mounting level. For mounting the 19” (482.6 1) Extended delivery times. mm) attachment level in the foremost mounting position, choose the version Accessories: with straight trim panel. − TS punched section with mounting flange 17 x 73 mm for the inner mounting level, Material: see from page 652 Carbon steel − PS punched section without mounting flange, 23 x 73 mm, see page 658 Surface finish: Spray-finished Note: The installation of depth stays, e.g. 7827.600/.800 Color: is not possible. RAL 7035 Configuration: Assembly parts Rittal Catalog 33/System accessories Metric measurements for are exact, imperial measurements are rounded 769
rittal
To see the actual publication please follow the link above